新闻中心

NEWS CENTER

  • PCB分板机常见的故障现象及处理方法
  • 本站编辑:杭州欧海自动化设备有限公司发布日期:2021-04-09 17:36 浏览次数:

1.如电源开关翻开后指示灯不亮:一种可能是保险丝熔段,需改换保险丝;另一种可能是紧急开关未打开。

2.行程不准:一种可能是行程计数器坏,需改换;另一种可能是行程计数器灰尘太多,清算灰尘即可。

3.刀撞左侧板:一种可能是左行程光感开关坏,需改换;另一种可能是左行程开关灰尘太多,清算灰尘即可。

4.刀撞右侧板:一种可能是右行程光感开关坏,需改换;另一种可能是右行程开关灰尘太多,清算灰尘即可。

5.电机转动,刀不转:连轴器顶丝松动,翻开后壳,顶紧顶丝即可。

PCB分板机

PCB分板机订购,分板机厂家,推荐欧海自动化!

1. if the indicator light is not on after the power switch is turned on: one is fuse fuse section, and the other may be that the emergency switch is not on.

2. inaccuracy of travel: one may be that the travel counter is bad and needs to be changed; the other may be that the travel counter has too much dust, so it can be cleared.

3. knife hitting left board: one is that the left travel light sensor switch is broken and needs to be changed; the other may be that the left travel switch has too much dust, so it can be cleaned.

4. knife hitting right board: one may be that the right travel light sensor switch is broken and needs to be changed; the other may be that the right travel switch has too much dust, so it can be cleaned.

5. motor rotation, knife does not rotate: the top wire of coupling is loose, open the rear housing and tighten the jacking wire.